5 – Installation and set-up MultiExact Gas Analyser
5.4.3 Changing passwords
If you change a password, ensure that you record the new password
somewhere safe. Otherwise, if you cannot recall the new password, you will
have to contact Servomex or your local Servomex agent for assistance.
Use the following procedure to change the supervisor and operator passwords:
1. Select
Settings
Password.
2. To change the supervisor password,
press the soft key, then enter
the new password: use the editing
method described in Section
4.10.
3.
To change the operator password,
press the soft key to display
the edit operator password screen,
press the soft key, then enter
the new password: Press the
soft key to display the settings screen
again
Figure 21 – The edit supervisor
password screen
5.4.4 Adjusting the contrast
1. Select
Settings
Contrast.
to increase or decrease the contrast
to the required level, then press the
soft key.
Figure 22 – The contrast screen
Hold the or soft key pressed in to adjust the contrast quickly.
38 05410001A / Revision 6
To Next Page
Loading...
Need help?
General
