MultiExact Gas Analyser 3 – Unpack the analyser
3 UNPACK THE ANALYSER
The analyser is heavy (see Section 2.1). Care must be taken when
handling. it is recommended that they are lifted with hands positioned
on either side on the base of the chassis.
1. Remove the analyser and any other equipment from its packaging.
2. Remove any protective plastic covers from the sample gas inlets and outlets on
the rear of the analyser (see Figure 2).
It is advisable that the protective covers are kept on just prior to fitting.
3. Inspect the analyser and the other items supplied, and check that they are not
damaged. If any item is damaged, immediately contact Servomex or your local
Servomex agent.
4. Check that you have received all of the items that you ordered. If any item is
missing, immediately contact Servomex or your local Servomex agent.
5. If you do not intend to use the analyser immediately:
• Refit any protective plastic covers.
• Place the analyser and any other equipment supplied back in its protective
packaging.
• Store the analyser as described in Section 10.1.
Otherwise, read Section 4 (Analyser user interface), then continue at Section 5
onwards to install, set up, and use the analyser.
Retain the shipping documentation and packaging for future use (for example,
return of the analyser to Servomex for servicing or repair).
05410001A / Revision 6 11
To Next Page
Loading...
Need help?
General
