Servomex SERVOPRO MultiExact - 2 SPECIFICATION; 2.1 General; 2.2 Environmental limits

MultiExact Gas Analyser 2 – Specification
2 SPECIFICATION
WARNING
The protection, accuracy, operation and condition of the equipment
may be impaired if the analyser is not installed in accordance with the
requirements of this and subsequent sections of the manual.
2.1 General
Dimensions:
length x height x width
* Add 100 mm to length (L) if valve block is fitted
to allow for the connector and cable.
Rack mountable analyser
(L x H x W)
478 x 133 x 435 mm (18.8 x 5.2 x 17 in.) *
478 x 133 x 483 mm (18.8 x 5.2 x 19 in.)
†
Bench mounted analyser
(L x H x W)
478 x 146 x 435 mm (18.8 x 5.7 x 17 in.)
#
478 x 180 x 435 mm (18.8 x 7 x 17 in.)
‡
Mass
< 12 kg
Electrical supply requirements
See Section 2.3
*
Without 19-inch rack mounting brackets.
†
With 19-inch rack mounting brackets fitted.
#
With front mounting feet retracted.
‡
With front mounting feet extended.
2.2 Environmental limits
Equipment is suitable for indoor use only
Ambient temperature range
Operation
5 to 45 °C
Storage
–20 to 60 °C
Operating ambient pressure range
101.3 kPa ± 10% (1.013 bar ± 10%)
Operating ambient humidity range
10 to 90% RH, non-condensing
Operating altitude range
–500 * to 2000
†
metres
Ingress protection
IP20
*
Below sea level.
†
Above sea level.
05410001A / Revision 6 5