Index
Manual mode with MOVISUITE
®
.................. 126
Releasing the brake / deactivating DynaStop
®
..................................................................... 129
Safety notes ................................................... 14
P
Paint protection cap............................................. 97
Paint protection film............................................. 97
Painting ............................................................. 233
Parameterization mode ..................................... 100
PC connection ..................................................... 90
Using the keypad............................................ 94
With interface adapter .................................... 90
PE connection ..................................................... 43
Plug connector .................................................... 56
Assignment............................................... 65, 89
Connection cable............................................ 57
Designation key.............................................. 56
Dimension drawing....................................... 276
Plug connector positions ................................ 61
Plug connector variant.................................... 62
Plug connector assignment
at the electronics cover .................................. 89
Plug connectors
Dimension drawing............................... 277, 278
Plug connector positions ................................ 59
Potentiometer f1 ................................................ 102
Potentiometer f2 ................................................ 103
Potentiometer t1 ................................................ 104
Power and torque .............................................. 233
Product names ...................................................... 8
Project planning
Data for drive selection................................. 217
Load capacity of the integrated braking resistor
..................................................................... 228
Project planning procedure .......................... 219
Project planning procedure ............................... 219
Protection devices ............................................... 45
Protective cover................................................... 96
Protective separation..................................... 13, 44
R
Relay output ...................................................... 242
Release brake without drive enable
Activating the function .................................. 129
Releasing the brake / deactivating DynaStop
®
.. 129
Removing the electronics cover .......................... 30
Repair................................................................ 205
Replacement
Drive unit ...................................................... 203
Electronics cover .......................................... 201
Memory module............................................ 202
Replacing the connection box / electronics cover
gasket........................................................... 212
Required tools and resources ............................. 27
Reset ................................................................. 138
Residual current device....................................... 42
Restriction of use................................................. 13
Rights to claim under limited warranty .................. 8
S
Safety functions................................................... 11
Safety notes
Assembly........................................................ 13
Designation in the documentation.................... 6
Installation ...................................................... 13
Installation altitude > 1000m ......................... 13
Meaning of the hazard symbols ....................... 7
Operation........................................................ 14
Preliminary information..................................... 9
Regenerative operation .................................. 14
Startup............................................................ 14
Structure of embedded..................................... 7
Structure of section-related .............................. 7
Screw fittings ..................................................... 254
Plug connector ............................................. 255
Potentiometer ............................................... 255
Pressure compensation................................ 254
Screw plugs....................................................... 254
Section-related safety notes.................................. 7
Self-locking helical-worm or SPIROPLAN
®
gear
units.............................................................. 229
Sensor inputs .................................................... 242
Separation, protective ......................................... 13
Service
Brake malfunctions....................................... 133
Device replacement...................................... 200
Evaluating fault messages ........................... 134
Extended storage ......................................... 206
Fault messages with parameterizable response
..................................................................... 136
LED displays ................................................ 139
25891936/EN – 05/20
Operating Instructions – MOVIMOT
®
advanced
307
To Next Page
Loading...
Need help?
General
