BEFORE
WEIGHING
MAINTENANCE
TROUBLESHOOTING
FOR YOUR
INFORMATION
USING THE
BALANCE
USING MORE CONVENIENTLY
101
Liquid Density Measurement
1
Fill the water tank with the sample
liquid, and make sure the device is
in liquid density measurement
mode.
2
If the balance display does not
display zero, press .
3
Lower the sinker and the sinker's
weight in air will be displayed.
4
Wait until the stability mark is
displayed then press and
"SINK" will be displayed as shown
in the image to the right.
5
Install the water tank on a base,
completely submerge the sinker
in the water tank so that there
are no air bubbles on the sinker,
and press .
6
The liquid density will be displayed.
7
Connect the printer and press
to output the results.
*
If the liquid solid density value is less than or equal to zero, "---" will be displayed.
To Next Page
Loading...
Need help?
General
