70
6
ADJUSTING RESPONSE AND STABILITY
The response and stability of the balance can be adjusted in several ways in accordance with the
installation environment (degree of vibration and so on) and the weighing application (whether solid
objects / clumps or poured liquids / powders are being weighed).
•
Stability: Thedegreetowhichtheweightreadingisstable,withlittleuctuation
•
Response: The speed of the reaction to changes in the weight on the pan
Set the optimum conditions for your application by following the procedure below.
Adjusting the stability and response in real time during
weighing
Pressing once in the weighing mode turns smart setting function on. By pressing and
, you can adjust stability and response.
"Easy Setting of Response and Stability" (^ page 72)
Adjusting (the stability mark)
The conditions for making (the stability mark) light up (the stability detection range and the
stability mark lighting timing) can be adjusted.
"Adjusting the Stability Mark" (^ page 74)
Selecting the weighing mode
The ATX-R/ATY-R series offers two basic weighing modes.
Select the right one in advance in accordance with the environment of use and the application.
General weighing mode
This is the fundamental mode in which
response and stability are given equal
emphasis.
(^ page 71)
Pouring mode
This is a weighing mode where response is
given priority over stability, which is suited to
operations where substances like liquids or
powders are poured out until a target weight
is reached.
(^ page 71)
To Next Page
Loading...
Need help?
General
