BEFORE
WEIGHING
MAINTENANCE
TROUBLESHOOTING
FOR YOUR
INFORMATION
USING THE
BALANCE
USING MORE CONVENIENTLY
85
V
Continued on next page
îš„
Counting Numbers of Pieces
1
Enter the piece counting mode
If you have returned to the weighing mode
(mode where grams or other units are displayed)
from the piece counting mode, then long press
for about 3 seconds to enter the piece
counting mode.
*
If the piece counting mode is not
established…
The preparations for piece counting
have not been completed. Make settings
according to "Preparation for Piece
Counting (Including Setting the Unit
Weight)" (^ page 82).
2
Select the item number.
Each time is pressed for about three
seconds, the selection moves to the next item
number and the corresponding item number
indication (from to ) is displayed.
*
If the display appears as shown to
the right…
This means that the unit weight has not
been set for the selected item number. To
make this setting, follow the procedure
in "Changing a Unit Weight, or Adding a
New Unit Weight" (^ page 86).
3
Place a container on the pan and press
The balance will be tared.
4
Add the sample to be counted into the container.
The number of pieces in the sample is indicated.
The operations of each of the keys after setting are summarized below.
On pressing twice.
Establishes the unit weight setting menu. (^ step 3 onward on page 86.)
On pressing ...
Pressing this key alternately displays the set unit weight (in grams) and the number
of pieces.
Press while the unit weight is displayed to output the unit weight.
While the unit weight is displayed, (the hold display symbol) is displayed.
OOn long pressing
...
The weighing mode is established.
Pressing the key once more returns you to the piece counting mode.
! ! ! ! ! !5
The piece counting symbol will light up.
! ! ! ! !1!0
! !-!-!-! !
To Next Page
Loading...
Need help?
General
