BEFORE
WEIGHING
MAINTENANCE
TROUBLESHOOTING
FOR YOUR
INFORMATION
USING THE
BALANCE
USING MORE CONVENIENTLY
77
7
SETTING UNITS
ATX-R/ATY-R series balances can be made to indicate weights in units other than the basic units of
grams by switching units with the key in the weighing mode.
You must register the units you will require in advance.
On shipment from the factory, the only unit registered is g (grams).
^
"Switching Units", page 37
Units That Can Be Displayed and Conversion Factors
Some of the units below cannot be selected in some countries due to legal restrictions.
Weight Unit (Weight Name) Gram Conversion
(*1)
Conversion Factor
(*2)
g (gram) 1 1
mg (miligram) 0.001 1000
ct (carat)
*3
0.2 5
mom (momme)
*6
3.75 0.2666667
User
*4, *5
Can be set as required by the user
(*4)
*1 If we take the value in the Gram conversion column to be "a", the formula is as follows.
"a" × balance weight reading (each unit) = value in gram units
*2 If we take the conversion factor to be "k", the formula is as follows.
"k" × value in gram units = balance weight value (selected units)
*3 The minimum indication for ct (carat) may vary depending on the production lot even if they are the same model.
NotapplicabletoveriedbalanceasalegalmeasuringinstrumentofATX84RandATY64R.
*4 Withuser-speciedunits,theconversionfactor(*2)andminimumindicationcanbesetasrequired.
Fordetailsonthemethodforsettinguser-speciedunits,see"SettingUser-SpeciedUnits"(^ page 79).
*5 Notapplicabletoaveriedbalanceasalegalmeasuringinstrument.
To Next Page
Loading...
Need help?
General
