BEFORE
WEIGHING
MAINTENANCE
TROUBLESHOOTING
FOR YOUR
INFORMATION
USING THE
BALANCE
USING MORE CONVENIENTLY
81
8
APPLICATION FUNCTION MODE
Application Function Mode
You can choose one of the three modes indicated below to suit the application.
Percentage
weighing
You can measure
weights as a
percentage of a
reference weight.
(^ page 87)
Specic gravity
measurement
You can measure
solid density and
liquid density in this
mode.
(^ page 91)
Formulation
This mode is
convenient when
mixing a number of
different samples
together according
to a formula.
(^ page 102)
Piece
counting
You can set the
unit weight of the
sample (item to be
weighed) and then
"count" the number
of pieces present.
(^ page 82)
*
When the application function mode is set…
Pressing for 3 seconds alternately selects the weighing mode (gram or other unit indication) and
the application function mode in use.
It can be used in combination with the comparator function (^ page 107).
If the power is turned OFF and back ON the balance will start up in the weighing mode but the application
function mode settings will be retained.
Pressing twice in the weighing mode displays the setting menu for each application function mode.
If you then press or , the top hierarchical level of the main menu appears.
The ow of the operation for displaying the menu is shown below.
Displays the main menu.
Percentage weighing
Formulation
Specic gravity
measurement
Percentage
reference value
setting menu
100 REF
etc.
Component number
and gross weight
setting menu
Specic gravity
measurement
settings menu
ELM.NUM
TOTAL
Piece counting
Unit weight setting
menu
5
100
Press
Press or
STAND
TOOLS