32
V
Installation
1
BEFORE WEIGHING
2
Enter the weight value.
If necessary, change the weight value to match
the weight that will be used for calibration. If
there is no need to change it, proceed to step
3
.
(If necessary enter the weight value.)
^
"Entering Numerical Values", page 45
For details on the weight values that can be
entered, see "Specications" (^ page 146).
3
Place the calibration weight on the
pan.
Open the glass door in the windbreak, place the
weight on the pan, and shut the glass door again.
Wait until the ashing weight value display
changes to a ashing zero.
*
Shut the glass door fully.
After placing a weight on the pan or
removing a weight from the pan, check
that the glass door is fully shut.
2!0!0.0!0!0!0
1!9!9.9!9!9!8
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
! !0.0!0!0!0
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
To Next Page
Loading...
Need help?
General
