Shimadzu GC-2014 Operation Manual

71
3.3 Analysis using capillary column
3
9
Specify detector setting.
 If detector is the FID
(1) Press .
(2) Move the cursor to the top, and select [On] on the
detector control.
(3) Press [Ignite] (PF1 key).
NOTE
Usually, leave "Filter Time Constant" as the default value
(200 ms).
If you need to improve S/N ratio, modify this parameter.
When all parameters are specified, the [STATUS]
indicator illuminates green, and the preparation
has been completed.
NOTE
Since [Zero to ready] has been set to [On] in default,
immediately after [STATUS] indicator illuminates green,
the detector signal is stabilized at 0 V.

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)