Shimadzu GC-2014 Operation Manual

3.3 Analysis using capillary column
70
7
Specify the setting of column temperature
and temperature program.
(1) Press key.
(2) Specify the initial temperature and temperature
program.
8
Start the GC.
(1) Press .
When the GC is in the status of "SYSTEM off", by
pressing , the screen in the figure appears.
(2) Specify "Start time" and "Clean up".
(3) Press [Start GC] (PF1 key) to start the instrument.
NOTE
Specify without exceeding the set temperature of
detector and the column allowable temperature limit.

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)