Chapter 5
MSC800
54 Operating instructions | SICK 8011540/14B8/2019-06-06
Subject to change without notice
Comments on the connections of the MSC800-0000 logic unit
USB 2 B type, USB1.1-compatible.
ETHERNET 10/100 Mbit/s
B type, USB2.0-compatible.
AUX (1/2) Two independent data interfaces.
Can each be used as RS-232 or RS-422/485 design. The RS-422/485 design is
not terminable in the MSC800.
AUX 1 For service purposes.
OUT 4 digital switching outputs, high-side switch.
2 relay outputs, changeover contact for switching protective extra-low voltage
IN 6 digital switching inputs, opto-decoupled.
3 x DC 24 V for supply of external sensors.
With switch S6-1/-2, isolated SGND of the inputs on GND of the MSC800 can be
TRIGGER 4 digital switching inputs, opto-decoupled. TRIG _1 and TRIG_2 are available
redundantly.
3 x DC 24 V for supply of external sensors.
With switch S5, isolated SGND of the inputs on GND of the MSC800 can be
INC 4 digital switching inputs, opto-decoupled. All switching inputs are available
redundantly.
2 x DC 24 V for supply of external sensors.
With switch S4, isolated SGND of the inputs on GND of the MSC800 can be
switched.
HOST (1/2) Two independent data interfaces.
Can each be used as RS-232 or RS-422/485 design. Terminals for HOST 1 are
redundantly available (red 1 to red
4). Data GND isolated from GND of the
MSC800 (GND_13).
The RS-422/485 design is not terminable in the MSC800 with command string.
CAN2 / CAN1 Two independent bus node points. Redundant terminals for each bus node.
CAN2 galvanically isolated from the MSC800 via digital isolator component, has
GND terminals isolated from GND (GND_12).
Termination with double DIP switch S22 and S21.
Two redundant, independent supply inputs.
Tab. 28 MSC800-0000: comments on connections X15 to X1
Further technical information (electrical values, etc.) on the connections can be found from
chapter 5.4.8 on page 64 to chapter 5.4.12 on page 69.
Important
To Next Page
Loading...
