SICK MSC800 User Manual

Chapter 3
MSC800
32 Operating instructions | SICK 8011540/14B8/2019-06-06
Subject to change without notice
Product description
3.4.6 Data processing
The SOPAS-ET configuration software can be used to configure result-dependent
assessment conditions as well as filters and sorting for the output formating of the read
result:
PROJECT TREE, MSC800, PARAMETERS, DATA PROCESSING, ASSESSMENT CONDITIONS
PROJECT TREE, MSC800, PARAMETERS, DATA PROCESSING, FILTER/SORTER FOR THE OUTPUT
FORMATING
3.4.7 Output formats
The read results (decoded codes) of the host interface can be output via selectable
physical data interfaces. Two different output formats (telegrams) can be defined for this
purpose. In addition, an output format can be defined for failed decoding (“No Read”),
as well as an output format for the heartbeat.
The SOPAS-ET configuration software can be used to configure the output formats:
PROJECT TREE, MSC800, PARAMETERS, DATA PROCESSING, OUTPUT FORMAT
3.4.8 Network
In the event of multi-side reading, the MSC800 carries out the coordination of the
ID sensors. The sensors and the MSC800 can be networked together via CAN bus.
The SOPAS-ET configuration software can be used to configure the network parameters:
PROJECT TREE, MSC800, PARAMETERS, NETWORK/INTERFACES/IOS, tabs NETWORK OPTIONS
and
MASTER/SLAVE




SICK MSC800 Specifications

General

Brand	SICK
Model	MSC800
Category	Controller
Language	English