COMMISSIONING 6
8026362 / V1-0/2022-03|SICK
Subject to change without notice
SUPPLEMENTARY OPERATING INSTRUCTIONS | VMS4100/5100
▸
Change the IP address of the configuration PC to the address range of the 2D LiDAR
sensor.
▸
Click on the Search settings button. The Connection Wizard helps you establish a
connection to a connected device.
▸
Select the Search using device family option and click Next to confirm.
• Limit the list to 2D LiDAR sensors in the LMS4000 device family and click Next to
confirm.
▸
Click Next to confirm each of the configured search settings, and click Finish to
complete.
Adjusting the LMS4x21
IP address
Starting the device
search
To Next Page
Loading...
