Operating Instructions 6-3 M90 Fusion Splicer
Issue 02/97 Taking Out of Service
AC Power Cord
Pull the AC power cord out of the splicer, coil it up and stow it away in the case lid.
Caution
The AC power cord must not project out of the holder.
Coil the AC Power Cord to a Diameter of Approx. 10 cm
Cleaning the Splicer
Remove dirt and the remains of fibers. Clean the LID system (section 7).
Tools
Place the tools in the tool bag and stow this in the case lid (see figure on opposite
page).
Caution
The tool bag must not project out of the holder.
Place Tools in the Tool Bag
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...