PFA-100 System – Instruction Manual (US) – Version 1.0.1
118
8.4.3 Printing stored test results
To print the stored test results, proceed as follows:
1. From the System Ready display, press the softkey located next to
Menus.
2. Press the numeric key 4 to select the Print Log option.
3. Press the numeric key 1 to select the Patient Results option.
4. Using the numeric keys, enter the number of patient results to be printed
(maximum 20), then press the softkey located next to Enter.
The system will begin printing the results of previous tests starting with
the most recent one.
Run
Print Last Run
Menus
System Ready
Insert Sample(s)
Then Press Run
01/11/07 10:30 AM
1 - Run Control
2 - Maintenance
3 - Setup
4 - Print Log Previous Screen
Previous Screen
1 - Patient Results
2 - Control Results
3 - Usage History
4 - Error Log
Note: Events or conditions (status messages) detected during the test
run are indicated below the printed test result. Refer to Chapter 12, for
full explanation of status messages.
To Next Page
Loading...
