Siemens PFA-100 System - Installing Fuses

3 Delivery and installation
PFA-100 System – Instruction Manual (US) – Version 1.0.1
113
3
3.2.3.1 Installing fuses
To install fuses on the analyzer, proceed as follows:
1. Pry open the fuse compartment with a small screw driver (see
Figure 3-14 and Figure 3-15) and remove the fuse holder from the
analyzer.
WARNING
Electric shock upon contact with live parts.
Death or serious injury can result.
• Before opening the analyzer and installing fuses, disconnect the mains
plug.
WARNING
Infection by contaminated parts of the analyzer.
Death or serious injury can result.
• Clean and disinfect the analyzer, see Chapter 10.
Figure 3-13 Location of fuse compartment with fuse holder
Fuse compartment