Configuring with Web Based Management
5.3 The "Information" menu
SCALANCE XB-200 Web Based Management
44 Configuration Manual, 04/2015, C79000-G8976-C360-02
●
Each component of a device has one or more LEDs that provide information on the
operating state of the device. Depending on its location, direct access to the device may
not always be possible. Web Based Management therefore displays simulated LEDs.
Unused connectors are displayed as gray LEDs. The meaning of the LED displays is
described in the operating instructions.
If you click this button, you open the window for the LED simulation. You can show this
window during a change of menu and move it as necessary. To close the LED simulation,
click the close button in the LED simulation window.
●
You can log out from any WBM page by clicking the "Logout" link.
In the navigation area, you have various menus available. Click the individual menus to
display the submenus. The submenus contain pages on which information is available or
with which you can create configurations. These pages are always displayed in the content
area.
The content area shows a graphic of the device. The graphic always shows the SCALANCE
XB-200 via which you called up the WBM.
The following is displayed below the device graphic:
●
Shows the PROFINET IO device name.
●
Shows whether EtherNet/IP is enabled ("On") or disabled ("Off").
●
Shows the system name of the device.
●
Shows the type of the device.
●
Shows the PROFINET IO application relation status.
– Online
There is a connection to a PROFINET IO controller. The PROFINET IO controller has
downloaded its configuration data to the device. The device can send status data to
the PROFINET IO controller. In this status, the parameters set by the PROFINET IO
controller cannot be configured on the device.
– Offline
There is no connection to a PROFINET IO controller.
To Next Page
Loading...
