Configuring with Web Based Management
5.3 The "Information" menu
SCALANCE XB-200 Web Based Management
Configuration Manual, 04/2015, C79000-G8976-C360-02
45
●
Power Line 1 / Power Line 2
– Up
Power supply 1 or 2 is applied.
– Down:
Power supply 1 or 2 is not applied or is below the permitted voltage.
●
Shows the fault status of the device.
Buttons you require often
The pages of the WBM contain the following standard buttons:
●
Refresh the display with "Refresh"
Web Based Management pages that display current parameters have a "Refresh" button
at the lower edge of the page. Click this button to request up-to-date information from the
device for the current page.
Note
If you click the "Refresh" button, before you have transferred your configuration changes
to the device using the "Set Values" button, your changes will be deleted and the
previous configuration will be loaded from the device and displayed he
re.
●
Save entries with "Set Values"
Pages in which you can make configuration settings have a "Set Values" button at the
lower edge. The button only becomes active if you change at least one value on the
page. Click this button to save the configuration data you have entered on the device.
Once you have saved, the button becomes inactive again.
Note
Changing configuration data is possible only with the "admin" login.
●
Create entries with "Create"
Pages in which you can make new entries have a "Create" button at the lower edge. Click
this button to create a new entry.
●
Delete entries with "Delete"
Pages in which you can delete entries have a "Delete" button at the lower edge. Click this
button to delete the previously selected entries from the device memory. Deleting also
results in an update of the page in the WBM.
●
The number of data records that can be displayed on a page is limited. Click the "Next"
button to page down through the data records.
●
The number of data records that can be displayed on a page is limited. Click the "Prev"
button to page up through the data records.
To Next Page
Loading...
