Siemens SCALANCE XB-200 - Page 86

Configuring with Web Based Management
5.4 The "System" menu
SCALANCE XB-200 Web Based Management
86 Configuration Manual, 04/2015, C79000-G8976-C360-02
Description of the displayed boxes
With Table 1, you can enable or disable all check boxes of a column of Table 2 at once.
Table 1 has the following columns:
●
Event
Shows that the settings are valid for all events of table 2.
●
E-mail / Trap / Log Table / Syslog / Fault
Enable or disable the required type of notification for all events. If "No Change" is
selected, the entries of the corresponding column in Table 2 remain unchanged.
●
Copy to Table
If you click the button, the setting is adopted for all events of table 2.
Table 2 has the following columns:
●
Event
The column contains the following values:
– Cold/Warm Start
The device was turned on or restarted by the user.
– Link Change
This event occurs only when the port status is monitored and has changed, see
"System > Fault Monitoring > Link Change".
– Authentication Failure
This event occurs when attempting access with a bad password.
– RMON Alarm
An alarm or event has occurred relating to the remote monitoring of the system.
– Power Change
This event occurs only when power supply lines 1 and 2 are monitored. It indicates
that there was a change to line 1 or line 2. See "System > Fault Monitoring > Power
Supply".
– RM State Change
The redundancy manager has recognized an interruption or restoration of the ring and
has switched the line over or back.
– Spanning Tree Change
The STP or RSTP topology has changed.
– Fault State Change
The fault status has changed. The fault status can relate to the activated port
monitoring or the power supply monitoring.
– Standby State Change
A device with an established standby connection (master or slave) has activated or
deactivated the link to the other ring (standby port). The data traffic was redirected
from one Ethernet connection (standby port of the master) to another Ethernet
connection (standby port of the slave).
– Loop detection
A loop was detected in the network segment.