Siemens SIMATIC ET 200pro - Page 104

Setting functions
8.3 Setpoints
SIMATIC ET 200pro FC-2 converter
104 Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
Interconnecting the motorized potentiometer (MOP) with the setpoint source
Figure 8-5 Motorized potentiometer as setpoint source
Figure 8-6 Function chart of the motorized potentiometer
Table 8- 2 Basic setup of motorized potentiometer
Parameter
Description
p1035
Motorized potentiometer setpoint higher
Interconnect these commands with sig-
nals of your choice.
p1036
Motorized potentiometer setpoint lower
p1040
MOP start value
(factory setting: 0 rpm)
Defines the start value [rpm] that is effective when the motor is switched on.
p1047
MOP ramp-up time (factory setting: 10 s)
p1048
MOP ramp-down time (factory setting: 10 s)
r1050
Motorized potentiometer setpoint after the ramp-function generator
p1070 =
1050
Main setpoint