Siemens SIMATIC ET 200pro - Configure the Inverter with Safety Integrated in SIMATIC Manager

Configure the hardware
5.3 Configure the hardware in SIMATIC Manager
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
63
Configure the inverter
Procedure
To configure the inverter, proceed as follows:
1. Select the inverter in the hardware catalog.
2. Drag and drop the inverter to a slot of your choice in the ET 200pro.
3. Enter the addresses of the inputs and outputs.
The input and output address must be identical.
You have now configured the inverter.
5.3.3
Configure the inverter with Safety Integrated in SIMATIC Manager
To use the integrated drive safety function of the inverter, you must configure an ET 200pro
with one of the F-switch or F-RSM modules.