Siemens SIMATIC ET 200pro - Handling STARTER; Change Settings; A.3 Handling STARTER

Appendix
A.3 Handling STARTER
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
237
A.3
Handling STARTER
A.3.1
Change settings
After the basic commissioning, you can adapt the inverter to your application as described in
the Commissioning guidelines (Page 67).
STARTER offers two options:
● Change the settings using the appropriate screen forms -
our recommendation
.
① Navigation bar: For each inverter function, select the corresponding screen form.
② tabs: Switch between screen forms.
If you change the settings using screen forms you do not need to know the parameter
numbers.
● You change the settings using the parameters in the expert list.
If you wish to change the settings using the expert list, you need to know the
corresponding parameter number and its significance.
Saving settings so that they are not lost when the power fails
The inverter initially only saves changes temporarily. You must do the following so that the
inverter saves your settings securely in the event of a power failure.
Procedure
Proceed as follows to save your settings in the inverter so that they are not lost when the
power fails:
1. Mark the appropriate drive in the project navigator.
2. Click the
Save (RAM to ROM) button.
You have saved your settings securely in the inverter in case of a power failure.