Siemens SIMATIC ET 200pro - Factory Setting of the Inverter Control

Commissioning
6.2 Preparing for commissioning
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
69
6.2.1
Factory setting of the inverter control
Switching the motor on and off
The inverter is set in the factory so that after it has been switched on, the motor accelerates
up to its speed setpoint in 10 seconds (referred to 1500 rpm). After it has been switched off,
the motor also brakes with a ramp-down time of 10 seconds.
Figure 6-1 Switching on and switching off the motor and reversing in the factory setting