Siemens SIMATIC ET 200pro - Enable the Diagnostic Alarm

Configure the hardware
5.3 Configure the hardware in SIMATIC Manager
SIMATIC ET 200pro FC-2 converter
66 Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
5.3.4
Enable the diagnostic alarm
The higher-level control evaluates the Diagnostic alarm of the ET 200pro in the control
program via the OB82.
Enable the diagnostic alarm
Procedure
Proceed as follows to activate the inverter’s diagnostic alarm:
1. Open the inverter properties.
2. Enable the inverter’s diagnostic alarm.
You have enabled the inverter’s diagnostic alarm.