Siemens SIMATIC ET 200pro - 1.2 Configuration options for ET 200 pro

Description
3.2 Spare parts and accessories
SIMATIC ET 200pro FC-2 converter
24 Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
No.
Components
Function
3 PROFINET interface
module with bus
module
The interface module interconnects the ET 200pro with the
PROFINET master and prepares the data for the electronic mod-
ules.The unit is delivered with the terminating module. The interface
module is already mounted on the bus module.The bus module is the
mechanical and electrical connection element between the various
ET 200pro modules.The terminating module terminates the
ET 200pro.The following interface modules are available for
PROFINET IO:
• IM154-4 PN
• IM154-6 PN
4 F-Switch with bus
module
The F-Switch is used in conjunction with the converter only for the
purpose of switching control signals from the higher-level controller
through PROFIsafe onto the internal switch-off signals F0 and F1 on
the ET 200pro backplane bus.
5 Converter with bus
module
The converter is connected to the higher-level controller by way of the
bus module and interface module. Power and motor are connected
using prefabricated cables
6
Terminating module
The ET 200pro bus is terminated with the terminating module
3.2
Spare parts and accessories
Optical cable
The optical cable is used to connect the IOP Handheld Kit with an RS232 interface to the
optical interface of the converter. Electronics integrated in the cable converts electrical
signals of up to 115 kBd into optical signals and vice versa.
Optical cable
Order No.
3RK19 22-2BP00
Overview of supplementary products
A complete, up-to-date listing of all supplementary products for the ET200pro can be found
at the following link:
Listing of supplementary products
(https://support.industry.siemens.com/cs/gb/en/view/65355810)