Siemens SIMATIC ET 200pro - Interconnecting Signals in the Inverter

Appendix
A.4 Interconnecting signals in the inverter
SIMATIC ET 200pro FC-2 converter
240 Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
Display options
In this area, you can set how the measurement results are displayed.
● Repeating measurements
This places the measurements that you wish to perform at different times above one
other.
● Arrange the curves in tracks
This means you define whether the trace of all measured values is displayed with respect
to a common zero line – or to separate zero lines.
● Measuring cursor on
This allows you to analyze the measuring intervals in more detail.
Figure A-4 Trace dialog box
A.4
Interconnecting signals in the inverter
The following functions are implemented in the converter:
● Open-loop and closed-loop control functions
● Communication functions
● Diagnosis and operating functions