Siemens SIMATIC ET 200pro - 2.9 Diagnosis possibilities

Installation
4.7 Mounting the converter
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
39
4.7
Mounting the converter
Frequency converter dimensions
Figure 4-9 Dimensions of the ET 200pro FC-2 [mm]
NOTICE
Clearance distance required to access the mini-USB connection
An additional clearance distance of 50 mm is required above the frequency converter to
allow access to the mini-USB connection.
This additional distance is required to enable to screw plug to be removed and a mini-USB
cable to be inserted into the connection. If the clearance distance is less than 50 mm then
access to the mini-USB connection will not be possible.
Prerequisites
When removing the device from the packaging, be sure not to touch or damage the rear
connections.
Place the converter on an even surface only.