Siemens SIMATIC ET 200pro - 10 Repair; Replacing the ET 200 Pro FC-2

SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
183
Repair
10
10.1
Replacing the ET 200pro FC-2
Replacing the ET 200pro FC-2
If the ET 200pro FC-2 requires to be replaced, due to a persistent fault condition, then the
procedures outline below should be performed.
WARNING
Physical injury or material damage as a result of unexpected drive behaviour
When replacing the ET 200pro FC-2 the converter should be replaced with another
converter with the same firmware version of the converter being replaced.
If the firmware versions are different, it is possible that the converter will not respond in
exactly the same manner as the old converter. This could result in unpredictable behaviour
of the replacement converter.
• If the firmware version of the replacement converter is different, then you have to
recommission the converter from the default factory settings.