Siemens SIMATIC ET 200pro - Saving Settings on a PC

Backing up data and series commissioning
9.2 Saving settings on a PC
SIMATIC ET 200pro FC-2 converter
172 Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
9.2
Saving settings on a PC
With the supply voltage switched on, you
can transfer the converter settings from the
converter to a PG/PC, or the data from a
PG/PC to the converter.
This requires you to have installed the
STARTER commissioning tool on your
P
G/PC.
You will find ad
ditional information about STARTER in Chapter: Tools to commission the
inverter (Page 27).
Inverter
→
PC/PG
Procedure
To back up the settings, proceed as follows:
1. Go online with STARTER :
.
2. Select the button "Download project to PG":
.
3. To save the data in the PG, select the button:
.
4. Go offline with STARTER :
.
You have backed up the settings.
PC/PG
→
inverter
The procedure depends on whether you also transfer settings of safety functions or not.
Procedure without enabled safety functions
To load the settings from the PG to the inverter, proceed as follows:
1. Go online with STARTER :
.
2. Select the button "Download project to target system":
.
3. To save the data in the inverter so that it is not lost when the power fails, select the "Copy
RAM to ROM" button:
.
4. Go offline with STARTER :
.
You have transferred the settings from the PG to the inverter.