Siemens SIMATIC ET 200pro - Protection of the Settings from Unauthorized Changes; Changing Settings

Setting functions
8.8 Safe Torque Off (STO) safety function
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
157
8.8.3.2
Protection of the settings from unauthorized changes
The safety functions are protected against unauthorized changes by a password.
Table 8- 21 Parameter
No.
Description
p9761
Entering a password
(factory setting 0000 hex)
Permissible passwords lie in the range 1 … FFFF FFFF.
p9762
New password
p9763
Confirm password
8.8.3.3
Changing settings
Procedure
To start commissioning the safety functions, proceed as follows:
1. Go online with STARTER
2. In STARTER, select the fail-safe functions.
3. Select "Change settings".
Parameter
Description
p0010 = 95
Drive commissioning parameter filter
Safety Integrated commissioning
p9761
Enter a password
(factory setting: 0000 hex)
Permissible passwords lie in the range 1 … FFFF FFFF.
p9762
New password
p9763
Confirm password