Siemens SIMATIC ET 200pro - Mounting the Connection Module for IM154

Installation
4.6 Mounting the connection module for IM154
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
37
Interface module
Bus m
odule 155 mm
Bus terminating module
The terminating module is now mounted.
4.6
Mounting the connection module for IM154
There are various connection modules with different connection methods for IM 154
● CM IM DP ECOFAST CU
● CM IP DP M12, 7/8"
● CM IM DP Direct
● IM154-4 PN
● IM154-6 PN
Requirements
The interface module must be mounted.
Required tools
Cross-tip screwdriver, size 2.
Procedure
1. Make the settings depending on the connection module and establish the internal
connections
The settings and connections of all communication modules are described in the manual
"ET 200pro Distributed I/O Devices"
2. Fastening the connection module with 4 screws.