Siemens SIMATIC ET 200pro - 2.6 Configuring (project planning)

Installation
4.4 Mounting the bus module
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
35
4.4
Mounting the bus module
Bus module dimensions
Figure 4-5 Dimensions of the Bus Module [mm]
The bus module connects the frequency converter to the ET 200pro backplane bus.
Procedure
Proceed as follows to mount the bus module:
1. Snap-mount the bus module onto the rack.
2. Push the bus module to the left until it engages into the interface module or the previous
installed electronic module.
Note
The bus module is fully secured in place when the frequency converter is installed onto
the bus module and the fixing screws on the frequency converter housing are fastened
into the mounting rail.
Figure 4-6 Mounting the bus module