Siemens SIMATIC ET 200pro - Configure the Inverter on PROFINET in SIMATIC Manager

Configure the hardware
5.3 Configure the hardware in SIMATIC Manager
SIMATIC ET 200pro FC-2 converter
58 Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
5.3.2
Configure the inverter on PROFINET in SIMATIC Manager
Description
Configuration in SIMATIC Manager consists of the following steps:
1. Configure the controller.
2. Configure the ET 200pro
3. Allocating device names and saving in the interface module.
4. Configure the inverter.
The procedure is described using the example of an IM 154-4 PN HF, V7.0 interface module.
Configure the controller
Procedure
To configure the PROFINET controller, proceed as follows:
1. Open the hardware configuration.
2. Select a SIMATIC CPU with PROFINET interface from the hardware catalog.
3. Add a PROFINET IO system to the CPU.