Siemens SIMATIC ET 200pro - 4.2 Project planning

Configure the hardware
5.3 Configure the hardware in SIMATIC Manager
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
57
Figure 5-4 Configuration
Inserting a converter into an "ET 200pro slot"
Select it from the hardware catalog "FC-2 1.1/1.5 kW" and drag it to the slot.
Figure 5-5 Frequency converter selection
Figure 5-6 Frequency converter in slot
Note
When engineering a failsafe application, you must insert an F
-RSM or F switch in front of the
frequency converter.