Siemens SIMATIC ET 200pro - Special modules

Commissioning
6.5 Basic commissioning
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
77
16.
A summary of all the settings is display.
If the setti
ngs are correct, select Continue.
17.
The final screen gives two options:
•
Save settings
•
Cancel Wizard
If save is selected, a factory reset will be performed then
the settings are saved to the Inverter memory. The loc
a-
tion of safe data is assigned using the "Parameter sa
v-
ing mode" function in "Parameter settings" in "Menu".
The basic commissioning of your converter is finished.
6.5.2
Basic commissioning with STARTER
STARTER and STARTER screen forms
STARTER is a PC-based tool to commission Siemens converters.
There are two methods of commissioning when using STARTER:
● You connect the computer, on which STARTER is installed, directly to the frequency
converter via an appropriate USB cable
● Using the computer, you access the head module on the frequency converter via a
fieldbus cable. In this case, the control must be switched off.
See also Components for assembling a frequency converter (Page 21)
The graphic user interface of STARTER supports you when commissioning. Most converter
functions are combined in screen forms in STARTER.
Commissioning the frequency converter when it is directly connected to the computer via a
USB cable is described in the following.
Preconditions for basic commissioning
You require the following to commission the converter using STARTER:
● An installed drive (motor and converter)
● A computer with Windows XP or Windows 7