Siemens SIMATIC ET 200pro - 4.5 LED displays

Configure the hardware
5.3 Configure the hardware in SIMATIC Manager
SIMATIC ET 200pro FC-2 converter
62 Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
Procedure
Proceed as follows to save the device names to the interface module:
1. Select "Target system → Edit Ethernet Node".
2. Select the ET 200pro: "Ethernet node" → "Browse".
If there is an online connection to the station, Step 7 lists all reachable stations on the
network
3. Select the ET 200pro by MAC address.
4. Write the device name in the "Assign device name" field.
5. Assign the name to the ET 200pro.
You have saved the device names in the interface module.