Siemens SIMATIC ET 200pro - Page 61

Configure the hardware
5.3 Configure the hardware in SIMATIC Manager
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
61
Procedure
To assign the device name to the ET 200pro, proceed as follows:
1. Open the screen with the ET 200pro properties.
2. Assign a unique device name of your choice.
You have assigned the device name to the ET 200pro.
Saving device names in the interface module
Preconditions
● Your PC/PG is connected to the interface module via an Ethernet connection.
● A micro memory card is inserted in the interface module (this is no longer required
depending on the type of interface module).