Siemens SIMATIC ET 200pro - 4.4 Diagnostics

Configure the hardware
5.3 Configure the hardware in SIMATIC Manager
SIMATIC ET 200pro FC-2 converter
60 Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
Configure the ET 200pro
Procedure
To configure the ET 200pro, proceed as follows:
1. Select the interface module in the hardware catalog.
2. Drag and drop the interface module into the PROFINET IO system.
You have configured the ET 200pro.
Assign device name
The IO controller accesses its IO device via the device name. The IP address is assigned
permanently to the device name.