Configure the hardware
5.3 Configure the hardware in SIMATIC Manager
SIMATIC ET 200pro FC-2 converter
64 Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
Further information about the F-switch and F-RSM modules is available online:
● F-switch: Manual
Distributed I/O System ET 200pro, Fail-Safe Modules
● F-RSM: Manual
SIMATIC ET 200pro Motor Starters
Configure the fail-safe inverter
Requirements
● STEP 7 V 5.3 SP3 or higher
● S7 Distributed Safety V5.4 or higher (F Configuration Pack V5.5 SP1 or higher)
● S7 F systems V5.2 SP2 or higher
To configure a fail-safe inverter, proceed as follows:
1. Configure an ET 200pro with an IM154-4 interface module
2. Add an F-switch or F-RSM.
To Next Page
Loading...
