Siemens SIMATIC ET 200pro - Page 144

Setting functions
8.7 Application-specific functions
SIMATIC ET 200pro FC-2 converter
144 Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
STARTER shows whether you change settings online in the inverter or change offline in the
PC (
/ ).
You sw
itch over the mode using the adjacent
buttons in the menu bar.
Procedure
To change over the units with STARTER, proceed as follows:
1. Select the configuration
2. Go to the "Units" tab in the configuration screen form to change over the units
3. Changing over the system of units
4. Select process variables of the technology controller
5. Adapting to the line supply
6.
Save your se
t-
tings.
7.
Go online.
The inverter
signals that
offline, other
units and pr
o-
cess variables
are set than in
the inverter
itself.
8.
Accept these
settings in the
inverter.
You have changed over the units.