Siemens SIMATIC ET 200pro - B.3 Disconnecting module 400 V

Repair
10.3 Firmware upgrade and downgrade
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
195
15.
Take your settings over from your data
backup to the converter.
See also Section:
Transferring the set-
tings from the memory card
(Page 171).
15.
If the firmware upgrade was succes
sful,
the converter LED RDY turns green after
several seconds.
16.
Reconnect all connectors.
17.
Take your settings over from your data
backup to the converter.
See also Section:
Transferring the set-
tings from the memory card (Page 171).
You have updated the converter's firmware to an older version and have adopted your saved
settings in the converter.