Siemens SIMATIC ET 200pro - Page 41

Installation
4.7 Mounting the converter
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
41
Procedure
Proceed as follows to mount the converter:
1. Plug the converter into the bus module so that the two domes on the rear engage in the
guide holes of the bus module.
2. Holding the converter firmly against the module rack, screw it in place with 4 screws on
the top and 4 screws on the bottom.
The upper 4 screws simultaneously fasten the bus module.
①
Connection module
②
Interface module
③
Frequency converter
④
Bus terminating module
Figure 4-12 Mounting the frequency converter
The converter is mounted.