Siemens SIMATIC S5 ET 200U - Address Ids for the Modules in an et 200 U(DP Standard) Station

5-10
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
Table 5-2 Address IDs for the Modules in an ET 200U(DP Standard) Station
Order No. of
Module
Address ID
ET 200U(DP Standard)
Address
Scope
(Byte)
Delay
Time
(ms)
1
Ad-
dress
Area
Current
Con-
sumption
Power
Loss
(W)
Order Code Decimal No.
(Byte)
(ms)
1
Area
sumption
(mA)
(W)
Digital Inputs 6ES5 ...:
420–8MA11 8DI 016 1 2.5 to 5 Digital 16 0.8
421–8MA12 8DI 016 1 2.3 to 4.5 Digital 34 1.6
422–8MA11 – 017 or 080
2
2
3
3 to 4 Digital
or ana-
log
50 4.5
430–8MB11 8DI 016 1 1.4 to 5 Digital 5 2
430–8MC11 8DI 016 1 10 to 20 Digital 16 2.8
430–8MD11 8DI 016 1 10 to 20 Digital 16 2.5
431–8MA11 8DI 016 1 4 to 5.5 Digital 32 2
431–8MC11 8DI 016 1 10 to 20 Digital 32 2.5
431–8MD11 8DI 016 1 10 to 20 Digital 32 3.6
433–8MA11 8DI 016 1 1 to 10 Digital 6 2.4
437–8EA12 8DI 016 1 40 Digital 50 0.45
Digital Outputs 6ES5 ...:
440–8MA11 8DQ 032 1 < 1 Digital 15 3
440–8MA21 8DQ 032 1 < 1 Digital 15 4.8
441–8MA11 8DQ 032 1 < 1 Digital 14 3.5
450–8MB11 8DQ 032 1 < 1 Digital 15 5
450–8MD11 8DQ 032 1 < 1 Digital 14 3.5
451–8MA11 8DQ 032 1 < 1 Digital 24 4
451–8MD11 8DQ 032 1 < 1 Digital 25 3.5
451–8MR11 8DQ 032 1 < 1 Digital 30 1.6
451–8MR12 8DQ 032 1 < 1 Digital 30 1.6
452–8MR11 8DQ 032 1 < 1 Digital 14 2
453–8MA11 8DQ 032 1 < 1 Digital 20 1
457–8EA12 8DQ 032 1 < 1 Digital 55 0.5
1 For an input module, the delay time is the time between a signal change at an input and a change of state on the I/O
bus. For an output module, the delay time is the time between a signal change on the I/O bus and a change of state
at an output.
2 The module can also be input with an analog address ID.
3 The module occupies an additional 2 output bytes in the ET 200U station but not in the COM ET 200.
ET 200U(DP Standard): AddressAssignm.,Starting–Up, DiagnosingFaultsUsing COM ET 200