4-6
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
If you entered “N” for the ET 200 system parameter “Dual–port RAM addr.”,
you must select one of the permissible areas for linear addressing (P or Q).
If you entered “Y” for the ET 200 system parameter “Dual–port RAM addr.”,
you must enter the abbreviation of the peripheral area (P or Q) and the dual–
port RAM page number. The permissible dual–port RAM page numbers are
derived from the basic dual–port RAM page number).
Examples: “P0” for dual–port RAM page number 0 in the P peripheral
area.
“Q1” for dual–port RAM page number 1 in the Q peripheral
area.
Press <F7> (HELP) to select the station type:
5. If you want to configure an ET 200U(DP Siemens), select “ET 200U”.
6. Press <F6> (ENTER) to confirm your entries..
Result: COM ET 200 accepts the entries and fills the screen (: Configu-
ration field):
STATION
–
DELETE
STATION
NEW
STATION
ADDRESS
ASSIGN. ENTER HELP EXIT
F2 F3 F4 F5 F6 F7 F8F1
Station number: 3
Program file selected: TEST@@ET.200
SIMATIC S5 / COM ET 200
CONFIGURING
Area: P
Station type: ET 200U
Station name:
Next available address: DI: DQ: AI: AQ:
Configuration: Module address: I: Q:
0.
1.
2.
3. 4. 5.
6.
7.
8.
9.
10.
11. 12. 13.
14.
15.
16.
17.
18.
19. 20. 21.
22.
23.
24.
25.
26.
27. 28. 29.
30.
31.
STATION
+
Figure 4-3 ET 200U(DP Siemens): CONFIGURING Screen (3)
“Area”
“Station Type”
ET 200U(DP Siemens): AddressAssignment,Starting–Up,Diagnosing Faults Using COMET200
To Next Page
Loading...
