Siemens SIMATIC S5 ET 200U - Coding the I;O Modules in an et 200 U(DP Standard;Fms)

6-18
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
Table 6-12 Coding the I/O Modules in an ET 200U(DP Standard/FMS)
Order No. of
Module
Type Length Access
Mode
1
Object
Code
2
Delay
(ms)
Current
Con-
sumption
(mA)
Power
Loss
(W)
Electronic cam controller module IP 264:
264–8MA11
3
4unsigned16
*
2
*
R/W 8 120 4
High Speed Sub Control IP 265:
4
265–8MA01 4unsigned16
*
2
*
R/W 8
CP 521 BASIC:
521–8MB11 4unsigned16
*
2
*
R/W 8 180 1.6
CP 521 SI:
521–8MA21 4unsigned16
*
2
*
R/W 8 140 1.2
330–8MA11
or no module
– – – – 0
* Since this module has both inputs and outputs, an “input” and an “output” object are generated.
1 Meanings of abbreviations: R = Read (read access) und W = Write (write access).
2 Meanings of the abbreviations: 7 = Simple–Variable, 8 = Array. The FMS master can access an array element via a
subindex.
3 The module requires two slots.
4 The IP 265 can only be operated in Slow Mode.
ET 200U(DP Standard/FMS): Modes, Settings and Comm. Capabilities of IM 318–C