Siemens SIMATIC S5 ET 200U - Address Ids for the Modules in an et 200 U(DP Standard) Station

5-12
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
Table 5-4 Address IDs for the Modules in an ET 200U(DP Standard) Station
Order No. of
Module
Address ID
ET 200U(DP Standard)
Address
Scope
(Byte)
Delay
Time
(ms)
1
Ad-
dress
Area
Current
Con-
sumption
Power
Loss
(W)
Order Code Decimal No.
(Byte)
(ms)
1
Area
sumption
(mA)
(W)
Input/Output Module:
482–8MA11
–8MA12
–8MA13
– 049 or 112
1
2* Digital
or
analog
50 4.5
Power Supply Module:
935–8ME11
2
8DI/8DI 016/016 – Digital 7.5
Simulator Module:
788–8MA11
8DI 016
1
< 0.2
Digital
30
0.3
8DQ 032
1 Digital 30
Timer Module:
380–8MA11 8DX 048 1* Digital 10
Counter Modules:
385–8MA11 8DX 048 1* 0.18 Digital 20 2.5
385–8MB11 2AX 241 4* Analog 70 1.9
Comparator Module:
461–8MA11 8DI 016 1 5 Digital 35 0.3
PID Controller Modules:
3
262–8MA11
–8MA12
4AX 243 8* 100 ...
200
Analog 20
262–8MB11
–8MB12
4AX 243 8* 100 ...
200
Analog 20
Position Control Modules:
263–8MA11
2
4AX/000 243/000 8* Analog 120 4
266–8MA11 4AX 243 8* Analog
267–8MA11 2AX 241 4* Analog 150
* The address scope is necessary for the inputs and the outputs (i.e. if the address scope is 2 bytes, 2 bytes are used
for the inputs and 2 bytes are used for the outputs). Since COM ET200 assigns the addresses for these modules
optionally, inputs and outputs can have different start addresses.
1 The module can also be addressed as 1–channel analog module
2 The module occupies 2 slots.
3 You can address a PID controller module in an ET 200 system at least every 200 ms. You cannot use function
blocks FB61 and FB62.
ET 200U(DP Standard): AddressAssignm.,Starting–Up, DiagnosingFaultsUsing COM ET 200