4-13
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
Table 4-4 Address IDs for the Modules in an ET 200U(DP Siemens)
Order Num-
ber of Module
Address ID
ET 200U
(DP Siemens)
Address
Scope
(Byte)
Delay
Time
(ms)
1
Address
Area
Current
Consump-
tion (mA)
Power
Loss
(W)
IP 264 Electronic Cam Controller:
264–8MA11
1
223/000 8* Analog 120 4
IP 265 High Speed Sub Control :
265–8MA01
2
223 8* Analog
CP 521 BASIC:
521–8MB11 223 8* Analog 180 1.6
CP 521 SI:
521–8MA21 223 8* Analog 140 1.2
330–8MA11
or no module
plugged in
000 0 0
* The address scope is necessary for the inputs and the outputs (i.e. if the address scope is 2 bytes, 2 bytes are used
for the inputs and 2 bytes are used for the outputs). Since COM ET200 assigns the addresses for these modules
optionally, inputs and outputs can have different start addresses.
1 The module occupies 2 slots.
2 IP 265 can be operated in Slow Mode only. Please refer to Section 4.2.1 for the Slow Mode setting.
ET 200U(DP Siemens): AddressAssignment,Starting–Up,Diagnosing Faults Using COMET200
To Next Page
Loading...
