9-55
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
9.10 IP 265 High Speed Sub Control (6ES5 265–8MA01)
Technical Specifications
Address ID for ET 200U
(The slow mode setting is des-
cribed in section 4.2.1 and sec-
tion 5.1.1, figure 5-5)
DP Siemens
DP Standard
223
4AX or 243
Current consumption from
+9 V (CPU)
<175 mA
Signal status display only for 24 V inputs
and 24 V outputs
(green LEDs)
Operating status display STOP (red LED)
RUN (green LED)
Memory submodule EPROM/EEPROM
Weight approx. 300g (10.5oz)
Digital 24 V Inputs (9–pin sub D connector)
Number of inputs 8
Galvanic isolation no
Status display Yes, on 5 V side
Input voltage L+
Rated value
for “0” signal
for “1” signal
24 V DC
0 to 5 V
11 to 30 V (IEC 65A)
Input current at “1” signal typ. 6.5 mA
(IEC 65 A)
Connection of 2–wire BERO possible
(zero signal current
1,5 mA)
Input frequency max. 10 kHz
Cable length (shielded) max. 100 m (328 ft)
Delay time of input circuit
Rising edge
Falling edge
typ. 15 ms
typ. 10 ms
Function Modules
To Next Page
Loading...
